Cruise Control Switch: Testing and Inspection
CRUISE CONTROL SWITCH INSPECTION [MZR 2.5]
1. Disconnect the negative battery cable and wait for 1 min or more. Removal and Replacement
2. Remove the driver-side air bag module. Driver-Side Air Bag Module Removal/Installation
3. Disconnect the clock spring connector (part wiring harness-side). Service and Repair
4. Inspect for resistance and continuity between clock spring (part wiring harness-side) terminals B-C using a tester.
- If not as specified, replace the steering switch. Service and Repair
5. Apply battery positive voltage to clock spring (part wiring harness-side) terminal D, and connect terminal E to ground.
6. Verify that the LED illuminates.
- If the LED does not illuminate, replace the steering switch. Service and Repair