Throttle Position Sensor: Testing and Inspection

THROTTLE POSITION (TP) SENSOR INSPECTION [MZR 2.5]

CAUTION:
- The inspection cannot be performed with this method correctly if there is a malfunction of the APP sensor or throttle valve actuator. Verify that no DTCs related to the APP sensor or throttle valve actuator are stored before the inspection.

NOTE:
- The TP sensor cannot be removed as a single unit. When replacing the TP sensor, replace it the throttle body as a single unit.

1. Connect the M-MDS to the DLC-2.






2. Switch the ignition to ON.

3. Verify that the TP sensor output voltage (PID: TP1, TP2) is within the specification. On-Board Diagnostic Test Component Tests and General Diagnostics

- If not as specified, replace the throttle body. Service and Repair