Clutch Pedal Assembly: Service and Repair

CLUTCH PEDAL REMOVAL/INSTALLATION [G66M-R]

1. Disconnect the negative battery cable. Removal and Replacement

2. Remove the battery and battery tray. Removal and Replacement

3. Remove the cowl panel. Cowl Panel Removal/Installation

4. Remove in the order indicated in the table.

5. Install in the reverse order of removal.

6. Fully depress the clutch pedal, and verify that the engine starts.









Clutch Pedal Installation Note

1. Add the clutch fluid, bleed the air, and inspect for leakage after the installation. Service and Repair

2. After installing the clutch pedal, inspect the clutch pedal. Adjustments

Starter Interlock Switch Installation Note

CAUTION:
- The starter interlock switch may not operate normally if the rod is pushed in. Do not push in the rod when installing the starter interlock switch.

1. Insert a new starter interlock switch into the pedal bracket hole in the direction of arrow A.

2. While pressing the starter interlock switch in the direction of arrow A, slide it until it locks in the direction of arrow B to secure it.

3. Fully depress the clutch pedal in the direction of arrow C, and verify that a click sound from the starter interlock switch is heard.