Power Door Lock Actuator: Testing and Inspection
DOOR LOCK ACTUATOR INSPECTION
Door Lock Actuator
1. Position the door glass so that the distance between the top of the front door glass and top of the front beltline molding is 110 mm {4.33 in}.
2. Disconnect the negative battery cable. Removal and Replacement
3. Remove the following parts:
a. Door trim Door Trim Removal/Installation
b. Door speaker Door Speaker Removal/Installation
c. Inner handle Service and Repair
d. Door module panel Door Module Panel Removal/Installation
e. Door glass Service and Repair
4. Apply battery positive voltage and connect the ground to the corresponding door lock actuator terminals and inspect the door lock actuator operation.
- If not as specified, replace the door lock actuator.
( )
RH
Door Lock-link Switch
1. Position the door glass so that the distance between the top of the front door glass and top of the front beltline molding is 110 mm {4.33 in}.
2. Disconnect the negative battery cable. Removal and Replacement
3. Remove the following parts:
a. Door trim Door Trim Removal/Installation
b. Door speaker Door Speaker Removal/Installation
c. Inner handle Service and Repair
d. Door module panel Door Module Panel Removal/Installation
e. Door glass Service and Repair
4. Inspect for continuity between the door lock-link switch terminals.
- If not as specified, replace the door lock actuator.
Door Key Cylinder Switch
1. Position the door glass so that the distance between the top of the front door glass and top of the front beltline molding is 110 mm {4.33 in}.
2. Disconnect the negative battery cable. Removal and Replacement
3. Remove the following parts:
a. Door trim Door Trim Removal/Installation
b. Door speaker Door Speaker Removal/Installation
c. Inner handle Service and Repair
d. Door module panel Door Module Panel Removal/Installation
e. Door glass Service and Repair
4. Inspect for continuity between the door lock-link switch terminals.
- If not as specified, replace the front door lock actuator.
