Operation CHARM: Car repair manuals for everyone.

Removal and Replacement





SEAT REMOVAL/INSTALLATION

WARNING:
- Handling a seat (with built-in side air bag) improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings before handling a seat (with built-in side air bag). Air Bag System Service Warnings

CAUTION:
- After removing a seat, do not operate the slider lever. If the slider lever is operated, the left and right slide positions will deviate, and the slide adjuster may be damaged after the seat is installed.
- Verify that there are no malfunctions in the sliding mechanism after installing a seat.
- When performing the procedure with a seat removed from the vehicle, perform the procedure on a clean rag so as not to damage or soil the seat.
- When the passenger's seat is removed, perform the seat weight sensor inspection using the M-MDS after installing the passenger's seat. Component Tests and General Diagnostics
- When the passenger's seat is replaced with a new one, perform the seat weight sensor calibration using the M-MDS. Programming and Relearning

1. Turn the ignition switch to the LOCK position.

2. Remove the battery cover.

3. Disconnect the negative battery cable and wait 1 min or more. Removal and Replacement

4. Press connector tab A in the direction of arrow.






5. Pull out the connector lock in the direction of arrow and disconnect the connector.






6. Remove the anchor cover. (passenger-side) Service and Repair

7. Remove the bolts, then remove the seat.






8. Install in the reverse order of removal.

9. Perform the seat weight sensor initialization procedure. Programming and Relearning