Removal and Replacement

FUEL PUMP UNIT REMOVAL/INSTALLATION [LF]

WARNING:
- Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line Safety Procedure", while referring to "BEFORE SERVICE PRECAUTION".
- Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, before performing the fuel pump unit removal/installation, always complete the "Fuel Leak Inspection After Fuel Pump Unit Installation".

1. Follow "BEFORE SERVICE PRECAUTION" before performing any work operations to prevent fuel from spilling from the fuel system. Before Service Precaution

2. Remove the battery cover. Removal and Replacement

3. Disconnect the negative battery cable. Removal and Replacement

4. Perform the following procedure to remove the service hole cover.
a. To remove the back trim, remove the following parts:
i. Console Console Removal/Installation

ii. Quarter trim Quarter Trim Removal/Installation

iii. Scuff plate ( Service and Repair.)

iv. Tire house trim Tire House Trim Removal/Installation

v. Aeroboard Service and Repair

vi. Front seat back bar garnish Seat Back Bar Garnish Removal/Installation

b. Remove the back trim. Back Trim Removal/Installation

c. Remove the service hole cover.






5. Disconnect the quick release connector from the fuel pump unit. Quick Release Connector Removal/Installation

6. Disconnect the fuel pump unit connector.

7. Remove in the order indicated in the table.










8. Install in the reverse order of removal.

9. Complete the "AFTER SERVICE PRECAUTION". After Service Precaution