Two-Step Deployment Control System

DTC B1013 [TWO-STEP DEPLOYMENT CONTROL SYSTEM]

System Malfunction Location





Detection Condition

WARNING:
- Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.

- Calibration set value not within valid range

Possible Causes

- Seat weight sensor deformed or malfunction
- Load to or deformation of the seat belt rail
- Deformed front passenger-side seat under-bracket or frame
- Weight acting on front passenger-side seat during calibration
- Improperly installed front passenger-side seat part at time of calibration
- Deformed floor where attached to front passenger-side seat
- Seat weight sensor control module malfunction
- SAS control module malfunction

Diagnostic Procedure