AR77.20-P-1100-01A Adjust Sliding Jaws on Tilting/Sliding Roof

AR77.20-P-1100-01A Adjust Sliding Jaws On Tilting/Sliding Roof







1. Loosen screws (4) from slide angle on left and right.
2. Align titling/sliding roof precisely in center of cutout.
3. Move sliding angle to inside (arrow) until sliding jaws make contact with guide at side.
4. Check centricity of titling/sliding roof in cutout.
5. Tighten screws (4) on slide angle on left and right.







6. Remove guide plate (1) from sliding carrier (2).
7. Manually move titling/sliding roof cover and check side play of sliding jaws in relation to guide at several points.
Tilting/sliding roof panel should not cant, if necessary readjust sliding bracket, otherwise malfunctions can occur.

8. Install guide plate (1) on sliding carrier (2).