AP82.10-P-8260-01GX Set Low Beam

AP82.10-P-8260-01GX Set Low Beam

DANGER: Risk of death caused by high voltage at xenon headlamps. Risk of explosion/risk of fire caused by highly flammable materials in the vicinity of damaged xenon bulbs. Risk of injury caused by UV light, hot components at xenon headlamps and glass splinters produced by bursting xenon bulbs. Risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming into contact with skin

Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on xenon headlamps. Switch off entire lighting system. Wear insulated safety shoes, safety glasses and protective gloves. AS82.10-Z-0001-01A

Remove highly inflammable materials from the hazard area. Ensure sufficient ventilation in the working area.






1 Check low beam setting.
The light-dark boundary of the light beam must run along the horizontal separating line (4) and the angled line (5).










2 Correct the adjustment of the low beams if necessary by turning the adjusting screws (1, 2).
On vehicles with xenon headlamp unit: First connect STAR DIAGNOSIS and carry out a zero position adjustment in the headlamp range adjustment control unit in the xontrol unit adaptations menu.

Left figure: halogen headlamp
Right figure: xenon headlamp

1 Adjustment screw for height adjustment
2 Adjustment screw for side adjustment