AZ82.60-P-0001-01GZA Retrofit iPod Interface Wiring Harness

AZ82.60-P-0001-01GZA Retrofit iPod Interface Wiring Harness
- with CODE (527) COMAND APS with single DVD drive (with navigation)
- with CODE (512) COMAND APS with DVD changer

Component Identification:

1 Open glove box lid.
2 Unclip stop plug (14) from rear hole in glove box (15) and remove.
3 Lead iPod wiring harness (9) through hole in glove box (15) to the outside and route along existing wiring harnesses into installation opening of COMAND operating, display and controller unit (A40/3).
4 Plug hole in glove box (15) with grommet (13) on iPod wiring harness (9).

Component Identification:

5 Remove fiber optic cable coupling (16) from black, 40-pin coupling (3) and install at same position in black 40-pin coupling (5).

Only if fiber optic cable coupling (16) is installed.

6 Assemble black 40-pin coupling (3) and black 40-pin connector (4), lock in place, and stow in installation opening of COMAND operating, display and controller unit.
7 Wind felt tape around 1000 mm long section of iPod interface wiring harness (2) starting at branch-off line (arrow) of black 40-pin connector (4) and black 40-pin coupling (5).
8 Connect blue 18-pin coupling (7) to iPod interface (1) and lock in place.
9 Connect black iPod wiring harness coupling (10) to iPod interface (1).
10 Assemble white 2-pin connector (8) on iPod interface wiring harness (2) and white 2-pin coupling (12) on iPod wiring harness (9).