AZ82.60-P-0001-01RTA Retrofit iPod Interface Wiring Harness

AZ82.60-P-0001-01RTA Retrofit iPod Interface Wiring Harness
- with CODE (527) COMAND APS with single DVD drive (with navigation)
- with CODE (512) COMAND APS with DVD changer

Component Identification:

1 Make a mark on glove box (14) as illustrated and drill hole with a diameter of 20 mm.
Cordless drill/driver
gotis://G_58.0_01.1

Dimensions:
A = 25 mm
B = 25 mm

2 Open glove box lid and lead black iPod wiring harness coupling on iPod wiring harness (9) from the inside through hole in glove box (14) to the outside and plug hole with grommet (13).
3 Bring glove box (14) into working area and route iPod wiring harness (9) to iPod interface (1). Next, position glove box (14) in installation location and fix in place using two screws/bolts.
4 Connect black iPod wiring harness coupling (10) to iPod interface (1).

Component Identification:

5 Set down iPod interface wiring harness (2) in installation opening of COMAND operating, display and controller unit.
6 Remove fiber optic cable coupling (15) from black, 40-pin coupling (3) and install at same position in black 40-pin coupling (5).

7 Assemble black 40-pin coupling (3) and black 40-pin connector (4) and lock in place.
8 Connect blue 18-pin coupling (7) to iPod interface (1) and lock in place.
9 Assemble white 2-pin connector (8) on iPod interface wiring harness (2) and white 2-pin coupling (12) on iPod wiring harness (9) and wind felt tape around everything.
10 Strap down extended length of iPod interface wiring harness (2) and stow in front of iPod interface (1).