AZ82.60-P-0015-02GZC Retrofit Rear Entertainment Wiring Harness

AZ82.60-P-0015-02GZC Retrofit Rear Entertainment Wiring Harness
- with CODE (866) Preinstallation for rear entertainment system
- Rear-seat entertainment with a screen






000 589 13 99 00
Wiring harness repair kit, basic





220 589 04 99 00
New passenger vehicle wiring harness repair kit





Connection scheme
3 Screen (left)
4 Screen (right)
7 Wiring harness (left screen)
7.1 White 8-pin plug
7.2 White 8-pin connector
8 Wiring harness (right screen)
8.1 White 8-pin plug
8.2 White 8-pin connector
9 White 8-pin connector (left vehicle wiring harness)
10 White 8-pin connector (right vehicle wiring harness)
F4 Load compartment fuse and relay box
RD Red line





1 Remove white connector (23) from slot "P1" of load compartment fuse and relay box (F4).
The slot is marked with "P1".
2 Remove red line (RD) from contact cavity 3 of white connector (23).
The contact cavities are labeled.
3 Fit white connector (23) to slot "P1" of load compartment fuse and relay box (F4).





4 Extend red line (RD) by approx. 100 mm.
Hot air blower gotis://E_15.54_12.0
In vehicle without code (359) TELEAID emergency call system.
To extend the line, use a red line (RD 1) with the same cross-section. Use solder connectors (22) to connect the red lines (RD and RD1).





5 Remove black connector (24) from slot "P6" of load compartment fuse and relay box (F4).
The slot is marked with "P6".
6 Install red line in contact cavity 10 (arrow) of black connector (24).
In vehicles without code (359) TELEAID emergency call system.
The contact cavities are labeled.
Only carry out operation steps 7 to 11 for vehicles with code (359) TELEAID emergency call system.
7 Remove black and white line from contact cavity 10 of black connector (24).
The contact cavities are labeled.





8 Remove "SLK" contact of red line (RD).
9 Extend red line (RD) by approx. 100 mm.
Hot air blower gotis://E_15.54_12.0
To extend the line, use a red line (RD 1) with the same cross-section. Use a solder connector (22) to connect the red lines (RD and RD1).
10 Connect black and white line (BK/WH) to red line (RD 1).
Hot air blower gotis://E_15.54_12.0
Use a solder connector (22) to connect the red lines (RD 1) and the black and white line (BK/WH).





11 Install black and white line in contact cavity 10 (arrow) of black connector (24).
The contact cavities are labeled.
12 Attach black connector (24) to slot "P6" of load compartment fuse and relay box (F4).
The slot is marked with "P6".
13 Replace fuse with a fuse rating of 5 A with a fuse with a fuse rating of 7.5 A.
The fuse is on the front of the load compartment fuse and relay box (F4) in slot "60".





14 Connect white 8-pin connector (10) of vehicle wiring harness to white 8-pin plug (8.1) of wiring harness (8).
Illustrated on right side of vehicle. Installation on the left side of the vehicle is performed correspondingly.