Longitudinal Bench Seat
Installation Instructions91.1 Longitudinal bench seat
Type 463
In the above model with wheelbase 2850 mm, the Logitudinal bench seat can subsequently be installed on both sides. The mounting points under the side wall panelling for the seat frame and backrest frame are available as standard. The side wall panelling must be refinished in accordance with the installation instructions.
The installation Instructions are divided into the following sections:
A. Installation.
B. Parts
A. Installation
1. Remove edge protection, door pillar.
2. Remove panelling of rear pillar left and right.
3. Remove cap and unscrew seat belt bottom.
4. Remove cap from seat belt at top.
5. Unscrew seat belt.
6. Remove side wall panelling from rubber window frame.
7. Remove rubber seal of rear compartment door. Remove side wall panelling.
8. Unscrew roof paneling at rear.
9. Unclip dome light.
10. Remove ventilation cover.
11. Mark fastening bores for the supporting loops on the roof frame. Drill two holes dia. 3.5 mm. (Supporting loops are laterally reversed on the lift and right).
12. Treat bores with wax preservation.
13. Secure supporting loop and holder.
14. Approximately leave open roof panelling in the area of the supporting loop.
15. Reduce edge protection of rear door to 932 mm (upper cover of rear door opening).
16. Connect dome light, reassemble panelling and edge protection.
17. Punch 8 holes of dia. 18 mm in side wall panelling according to sketch diagram. Install side wall panelling.
18. Attach seat belt top and bottom.
19. Preassemble backrest frame, seat frame and bench seat.
20. Screw backrest frame with seat frame to side wall panelling.
21. Attach backrest cushion.
22. Apply step guard left and right. For this purpose degrease the adhesive surfaces on step of bumper.
23. Remove protective foil of step guard and stick on.
B. Parts:
NOTE: Use standard parts from your own stock.