AN91.12-P-0010-01RT Install 7th Seat

AN91.12-P-0010-01RT Install 7th Seat
- MODEL 251.0## /1## (except 251.077 /177) 1#











1 Position 7th seat (1) at installation location with aid of helper.
2 Fold up the seat surface of the 7th seat (1). Pull loop (33) backwards to do this.
3 Tighten front and rear nuts (28).





4 Open clips of covers (29) on base (21) of 7th seat (1).
5 Position belt end fitting (30) on floor of vehicle and secure with bolt (31).
6 Position seat belt buckle fitting (17) on rear retaining plate and secure with bolt (32).
Use seat belt buckle (34) from retrofit kit.
7 Position seat belt buckle (34) in cover of 7th seat (1) as shown.





Shown on installed rear seat

8 Remove armrests (47) from left and right rear seats. To do this, push catch on side of rear seat backrest (49) and simultaneously pull armrest (47) out of rear seat backrest (49) from the side.
On vehicles without code (575) Center console for 2nd row.
The catch is in the form of a ring around the pivot bearing of the armrest (47). This catch must be able to be felt through the backrest cover.
9 Close side opening in backrest cover of left and right rear seat with a cover from the retrofit kit.