AZ82.80-P-0002-02GZ Retrofit InCar Hotspot Holder

AZ82.80-P-0002-02GZ Retrofit InCar Hotspot Holder






1 Note "WPA" number of InCar Hotspot (1) on back of operator's manual.
The operator's manual is included in the installation kit. Only note the "WPA" number if this has not yet been attached to the rear of the operator's manual in the form of a sticker. The "WPA" number of the InCar Hotspot (1) is on the model plate.






2 Position bracket (13) on the back of the InCar Hotspot (1) as shown and screw in place with screws/bolts (14) and the corresponding nuts.






3 Connect cellular telephone system splitter/InCar Hotspot antenna line (3) and power supply wiring harness (6) to InCar Hotspot (1).






4 Mount InCar Hotspot (1) on trunk lining (15) with bracket (13).
The edge of the trunk lining (15) must be flush with the top edge of the bracket (13).

5 Mark appropriate bores for the threads in bracket (13) and drill to dia. 4 mm (arrow).
Cordless drill/driver
gotis://G_58.0_01.1

6 Tighten InCar Hotspot (1) with screws/bolts included in installation kit.