Procedures

AN88.30-P-0007-01GY Modify Bumper Lower Section
Model 164.8 except off-road appearance package,
- code U89





Front bumper

1 Route front optical underride guard (1) on front bumper lower section to correct installation position.
2 Mark position of holes (3) on front bumper lower section (2).
3 Remove front optical underride guard (1).
4 Drill dia. 8 mm holes on markings.
5 Debur holes.





Rear bumper

6 Route rear optical underride guard (4) on rear bumper lower section (5) to correct installation position.
7 Mark position of holes (6) on rear bumper lower section (5).

Only with trailer hitch, code 550

8 Mark hole for lug (7).
9 Remove rear optical underride guard (4).
10 Drill dia. 8 mm holes on markings.

Only with trailer hitch, code 550

11 Cut out hole for lug (7) in corresponding size.
12 Debur holes.





Rear bumper

13 Route reinforcement (8) on rear bumper lower section (5) to correct installation position.
14 Mark positions of holes (9) on rear bumper lower section (5).
15 Remove reinforcement (8).
16 Drill dia. 8 mm holes on markings.
17 Debur holes