AZ82.60-P-0001-02GZ Retrofit iPod Wiring Harness

AZ82.60-P-0001-02GZ Retrofit iPod Wiring Harness
- except CODE (498) Japan version

Only on vehicles with code 528 COMAND DVD USA (without navigation) or with code 530 COMAND DVD APS USA (with navigation)

1.1 Remove AUX bushing (11) from glove compartment (9).

The AUX bushing wiring harness (10) with AUX bushing (11) is no longer required.







Only on vehicles without code 528 COMAND DVD USA (without navigation) or without code 530 COMAND DVD APS USA (with navigation)

1.2 Break side passage (see arrow) out of glove compartment (9) with small flap tip screwdriver.

The passage is preperforated.

Component Identification:

2 Install interface connector (5) on iPod wiring harness (1) through passage into glove compartment (9) and plug with grommet (6).
3 Route wiring harness iPod (1) in the glove compartment (9) as per the picture.
4 Fasten the wiring harness iPod (1) in the glove compartment (9) with two felt strips (17) as per the picture (9).







5 Route interface connector (5) from iPod wiring harness (1) into radio recess and reinstall glove compartment.

Ensure that the wiring harness iPod (1) is not pinched when installing the glove compartment (9).