AZ82.70-P-0001-04GZY Retrofit Wiring Harness

AZ82.70-P-0001-04GZY Retrofit Wiring Harness.

Component Identification:

1 Detach wiring harness from connector.
2 Detach coupling (3) from connector.
3 Note color code of coupling in contact cavities.

The connection is reinstated in the stowage compartment after performance.







4 Disassemble and detach center console as far as necessary to remove stowage compartment (13)
5 Drill hole with diameter of A=8 mm in lower area.
6 Route detached end of iPhone wiring harness through and attach wiring harness in the corresponding contact cavities of the coupling.
7 Assemble connector of iPhone wiring harness again.

Do not damage the wiring harness by squeezing or pinching it.







8 Route wiring harness (1) below raised center console to interface (8) in dashboard and fix in place.

Do not damage the wiring harness by squeezing or pinching it.







9 Remove interface from the radio recess (see installation location at arrow).







10 Remove iPod wiring harness from interface and strap down in radio recess.
11 Connect coupling (5) of wiring harness (1) with interface.
12 Place interface in radio recess again.

Do not damage the wiring harness by squeezing or pinching it.