AZ82.85-P-0006-04GZ Retrofit Medianavigation Center

AZ82.85-P-0006-04GZ Retrofit MediaNavigation Center
- MODEL 164.1 /8 with CODE (830) China version






1 Position mounting frame (22) on MediaNavigation Center (1) and tighten using screws/bolts (23).






2 Connect black AUX coupling (8.2) of MediaNavigation Center connecting cable (8), as shown, to the yellow AUX jack on the MediaNavigation Center (1).
The black AUX coupling (8.2) is marked with a yellow flag (arrow).

3. Connect black Universal Serial Bus (USB) connector (8.3) of MediaNavigation Center connecting cable (8) to black USB coupling (1.6) of MediaNavigation Center (1).






4 Connect black 16-pin coupling (5.11) of MediaNavigation Center adapter wiring harness (5) to MediaNavigation Center (1).
5 Connect black 2-pin plug (5.8) of MediaNavigation Center adapter wiring harness (5) to black 2-pin microphone coupling (1.1) of MediaNavigation Center (1).
6 Connect black AUX signal connector (5.10) of MediaNavigation Center adapter wiring harness (5) to black AUX signal coupling (1.3) of MediaNavigation Center (1).






7 Connect antenna connector (5.7) of MediaNavigation Center adapter wiring harness (5) to black 1-pin antenna coupling (1.2) of MediaNavigation Center (1).
8 Connect transparent 1-pin plug ("REVERSE) (5.9) of MediaNavigation Center adapter wiring harness (5) to transparent 1-pin coupling ("REVERSE") (1.4) of the MediaNavigation Center (1).






9 Connect blue 13-pin plug (7.2) of Bluetooth module connecting cable (7) to blue 13-pin Bluetooth module coupling (1.7) of MediaNavigation Center (1).
10 Connect gray 1-pin Global Positioning System (GPS) coupling (14.1) of adapter line (14) to MediaNavigation Center (1).
11 Connect white 6-pin reversing camera coupling to MediaNavigation Center (1) slot (arrow).
Only in vehicles with code (218) Reversing camera.

12 Route all lines connected to the MediaNavigation Center (1) into the recess and fix in place using a cable tie so that clattering noise cannot occur.
The connection lines with the inscription "REMOTE IN", "M. CONT", "REMOTE OUT" and "GUIDE CONT" as well as the not yet connected black coupling on the MediaNavigation Center (1) are not required and they should be strapped down with the other wiring harnesses.