Remove/Install

Removal
1. Disconnect battery.
2. Pull control knobs from radio.
3. Remove radio molding.

Control Panel Moulding Removal:

4. Unclip molding for control unit (arrow and screw driver).

Control Panel Mounting Screws:

5. Remove both screws from left and right top (arrow).

Control Panel Removal:

6. Slightly pull out holder for control unit at top (arrow) and then lift out in upward direction.
7. Pull off electric plugs on left and right, as well as sockets for instrument lights.

Control Panel Mounting Bracket:

8. Remove three screws (arrow) and remove control unit.

Installation

Control Panel Mounting Bracket:

1. Place control unit into holder and install three screws (arrow).
2. Plug in 12 pin electric plugs left and right and lamp socket for instrument lights.

Control Panel Removal:

3. Insert holder for control unit from above into cutout and press on (arrow).

Control Panel Mounting Screws:

4. Fasten both screws at left and right top (arrow).
5. Clip-in molding for control unit.
6. Press-on radio molding.
7. Plug-on control knobs of radio.
8. Connect battery.
9. Check function of ACC. SEE Manual Function Tests. Manual and Visual Function Test of Automatic Climate Control