Computers and Control Systems: Technical Service Bulletins

• By Symptom
  • Driveability
    • Stalling and/or Cutting Out Complaints
    • Engine Hesitates, Cuts Out, Hard Start
    • Idle Speed at Times Too High or Low
    • Engine Cuts-Out, Cannot Be Restarted
  • Erratic Operation
    • Idle Speed at Times Too High or Low
  • Inoperative
    • Scan Tool (Impulse Counter ) - Failure, Improper Hook-Up
  • Poor performance
    • Engine Hesitates, Cuts Out, Hard Start
  • Starting problems
    • Stalling and/or Cutting Out Complaints
    • Engine Hesitates, Cuts Out, Hard Start
    • Engine Cuts-Out, Cannot Be Restarted
• All Technical Service Bulletins
  • Engine Control - Engine Control Module (N3/10) Flashing
  • Hand-Held Tester (HHT) - Updated Modules
  • Policy - HHT Warranty & Precautions
  • Scan Tool (Impulse Counter ) - Failure, Improper Hook-Up
  • Stalling and/or Cutting Out Complaints
  • Engine Hesitates, Cuts Out, Hard Start
  • Electronic Components - Warning Against Repair
  • Idle Speed at Times Too High or Low
  • Idle Speed Drops Below 1100 Rpm at Operating Temp.
  • Policy - Replacement Conditions of ECU After Accident
  • Engine Cuts-Out, Cannot Be Restarted
  • Overvoltage Relay/Harness - Update