Engine: Technical Service Bulletins
- Customer Interest
- By Symptom
- All Technical Service Bulletins
- Engine - Caution Prior to Degreasing
- A/T - Torque Converter Damaged By Engine Over-Revving
- Engine Overrev Damage in Vehicles with Auto. Trans.
- Oil Leak Between Timing Chain and Cyl. Head Covers
- External Oil Leaks
- Engine - Updated Components
- Engine - Break-In Oil New and Rebuilt
- Engine - Warning About Carbon Cleaning
- Tools - Oil Evacuation Equipment
- Engine - Hesitates/Cuts Out/Quits/Difficult to Start
- Engine - Hard Starting, Cuts Out, No Power, Vibrates
- Engine - Overrev Damage
- Spark Plug Wrench - Application and Update
- Ignition - Caution about Spark Plug Wrenches
- Camshaft - Updated Replacement Part
- Timing Chain - Riveted Connecting Link
- Valve Guides - Special Tools for Checking & Replacement
- Engine - Noisy Valve Lifters
- Engine - Oil Filter Housing O-Ring Inspection
- Piston - Ordering and Matching with Cylinder Bore
- Engine - Valve Cover, Modified Oil Separator
- Oil Leak From Drain Hole Opening on Left Side of Engine
- Engine - Cylinder Wall Damage Assesment
- Water Pump - Drainage Pipe Retrofitting Procedure
- Water Pump - Replacement Justification
- Engine - Rough/High Idle
- Engine Shakes at Idle
- Cruise Control - Inoperative/Engine Stall at Stop
- Engine Does Not Start
- Engine Surges in Idle at Operating Temperature
- Engine - Cuts on Acceleration/Hesitates
- Vehicle - New Dealer Technical Bulletin
- Engine - Oil Filter Precaution For O-Ring/Gasket
- Oil Filter - Modified Wrench
- Engine Block Heater - Installation/Cable
- Engine Block Heater - Installation/Cable Installation
- Overview
- Models 124, 126, 129, 201, 202, 210 (With Engines 103, 104)
- Models 129.066/067 (With Engine 119)
- Models 124, 126, 140 (With Engines 602.962, 603.970, 603.971)
- Engine - Block Heater Installation
- Main Bearings - Cross Reference
- Oil Leakage at Top Front Cover
- Maintenance - Factory Approved Service Products
- Engine - Stalls Then Restarts/Cuts Out During Coasting
- Engine - Oil Level Checking Procedure Revised
- Oils & Fluids - Factory Approved Products
- Valve - Tool Modification
- Valve Spring Compressor - Modifications
- Valve Springs - Tool Kit for Removing/Installing
- Engine - Universal Valve Spring Remover/Installer
- A/C - Not Functioning Properly
- Ignition System - Wires with Crimp-On terminals
- Spark Plug Connector - Special Tool
- Spark Plug Connector - Special Pliers
- Difficult Start, Vibration, Poor Power and Acceleration
- Engine - Oil Evacuation Equipment
- Gasoline Engine - Oil Sludging
- Hard Starting, Runs Rough
- Engine - Caution When Installing Head Bolts
- Instruments - (Oil Level Indicator) Testing & Function
- Engine is Difficult to Start When Warm
- Camshaft Oil Pipe - Revised Installation Procedure
- Fuel System - (CIS-E & CIS) Pressure Tester
- Fuel - CIS/CIS-E Fuel Pressure Tester
- Engine - Special Tool, Compression Recorder
- Engine - Compression Recorder Tool