Operation CHARM: Car repair manuals for everyone.

Automatic Trans (Federal)





A1e26 "CHECK ENGINE" warning lamp
A1p7 Electronic clock/tachometer
B2 Air flow sensor position indicator
B11/2 Coolant temperature sensor (EZL/CIS-E/2E-E)
B15 Altitude correction capsule
F1 Fuse and relay box
G1 Battery
G3/2 Heated O2-sensor
G3/2x1 Connector, O2-sensor heater coil
G3/2x2 Connector, O2-sensor signal
K1/1 Overvoltage protection relay, 87E (7-pole)
M1 Starter
M3/1 Fuel pump 1
M3/2 Fuel pump 2
N1/2 Electronic ignition control unit (EZL)
N3 CIS-E control unit
N6 A/C compressor control unit
N16/4 Fuel pump relay with kick-down cut-cut
S2/1 Ignition/starter switch
S16/1 Starter lock-out/backup lamp switch
S27/2 Deceleration shut-off microswitch
S29/2 Throttle valve switch, full load/idle
S29/2x1 Connector, throttle valve switch
S30/1 Kick-down switch
W3 Ground, left front wheelhousing (at ignition coil)
W7 Ground, right rear wheelhousing in trunk
W9 Ground, at left headlamp unit
W10 Ground, battery
W11 Ground, engine (connection point for ground wires)
X11 Diagnostic socket/terminal block (circuit TD)
X26 Connector, interior/engine (12-pole)
X27 Connector, starter harness
X35 Terminal block, terminals 30/61 (battery)
X36 Connector, fuel pump harness (1-pole)
X49/2 Connector, backup lamp/starter lock-out switch
Y1 Electrohydraulic actuator (EHA)
Y5 Switchover valve (automatic transmission)
Y6 Idle speed air valve
Y8 Start valve
Z Connector sleeve (solder joint in harness)

a to exterior lamp failure monitoring unit, terminal 13
b to cruise control

Color Code
bl blue
br brown
ge yellow
gn green
rt red
rs pink
sw black
vi purple
ws white

NOTE: Ground connection points without designation: Component is grounded directly to engine or chassis/body.