Computers and Control Systems: Technical Service Bulletins
- Customer Interest
- By Symptom
- Customer Interest
- Driveability
- Engine - Stalls Then Restarts/Cuts Out During Coasting
- Engine - Hesitates/Cuts Out/Quits/Difficult to Start
- Stalling and/or Cutting Out Complaints
- Engine Hesitates, Cuts Out, Hard Start
- Engine Cuts-Out, Cannot Be Restarted
- On-Off Ratio Won't Adjust After Repair, MIL on
- Cruise Control - Inoperative/Engine Stall at Stop
- Engine Surges at Idle at Operating Temp.
- Erratic Operation
- Erratic Shifting
- Inoperative
- Out of specification
- Poor performance
- Starting problems
- All Technical Service Bulletins
- Engine Control - Engine Control Module (N3/10) Flashing
- Hand-Held Tester (HHT) - Updated Modules
- Policy - HHT Warranty & Precautions
- Scan Tool (Impulse Counter ) - Failure, Improper Hook-Up
- EGR Valve - Testing
- Engine - Stalls Then Restarts/Cuts Out During Coasting
- Engine - Hesitates/Cuts Out/Quits/Difficult to Start
- Stalling and/or Cutting Out Complaints
- Engine Hesitates, Cuts Out, Hard Start
- Electronic Components - Warning Against Repair
- MIL ON ON/OFF Ratio Unadjustable After Repair Work
- Policy - Replacement Conditions of ECU After Accident
- O2 Sensors - Avoiding Bogus Test Results
- Engine Cuts-Out, Cannot Be Restarted
- On-Off Ratio Won't Adjust After Repair, MIL on
- Cruise Control - Inoperative/Engine Stall at Stop
- Engine Does Not Start
- Engine Surges in Idle at Operating Temperature
- Overvoltage Relay/Harness - Update
- Engine Surges at Idle at Operating Temp.