Clearing Diagnostic Trouble Codes

Erasing fault memory

Model 107:

013 Pulse counter
T1 Ignition coil
X92 Diagnostic test connector, 8-pin (flashing code)

Model 126:

013 Pulse counter
G1 Battery
X92 Diagnostic test connector B-pin (flashing code)

Once a fault has been rectified without the CIS-E control unit having been disconnected, the pulse indicated must be erased as follows:

^ After the pulse readout has been indicated for a waiting period of 2 seconds, press start button for 6 - 8 seconds.

Note: Each pulse indicated must be erased separately.

^ No readout indicates that stored fault has been erased.

^ If a digit (>1) is indicated, there are further faults in the system.