Removal and Installation of Spring Plate

Tightening Torques

Screw carrier to cylinder head M 1O x 30 30 ± 3.0 Nm

Screw compressor to holder M 8 x 90 2O ± 2.5 Nm

Nut M 8 to compressor shaft 16 ± 1.0 Nm

a) Spring Plate

Removal

1 Remove V-belt. Service and Repair





2 Position holding rod for spring plate and loosen nut.

Attention! Refrigerant system remains filled.





3 Loosen four fastening screws (arrows) from refrigerant compressor on holder.





4 Place refrigerant compressor on tube or the like as assembly aid (arrows).





5 Screw puller into spring plate and pull spring plate from compressor shaft.

Installation





6 Place spring plate on compressor shaft and tighten nut.





7 Check gap dimension and correct with spacing washer.





8 Fasten refrigerant compressor with four fastening screws (arrows) on holder.

9 Install V-belt. Service and Repair

10 Check air-conditioning system for function.