Shift Linkage: Adjustments

W4020 TRANSMISSION

1. Disconnect control rod from selector lever.
2. Set range selector lever into ``N'' position.
3. Loosen counternut and adjust control rod lengthwise so that there is approximately .004 inch (1 mm) clearance between selector level and ``N'' stop on gear change plate.
4. Attach control rod and tighten counternut.

W4A040 TRANSMISSION

1. Move selector to P position and turn ignition key to 0 position, then raise and support vehicle.
2. Loosen cable retaining bolt, then pull jacket of cable until lock lever rests against the cam.
3. On all models, torque cable retaining bolts to specifications.