Rear Seat (Power) and Adjustment, Remove/Install
Removal, reinstallation of electric rear seat adjustmentRemoval
1 Unscrew both mounting screws in the seat bench in the left and right rear footwell.
Mounting (Rear Sear Backrest):
2 Lift rear seat at the front and pull out in driving direction.
3 Unscrew screws left and right from the rear seat backrest (arrow) and push upwards out of the bracket.
Connector (Seat Heater):
4 With installed seat heater separate 2-pole plug connection for seat bench and backrest (arrow) on both sides.
Drive:
5 Unscrew mounting screws (1) from slide and loosen flexible shaft (2) from seat bench drive and remove adjusting device.
Lock (Flexible Shaft):
6 To remove the core in the flexible shaft, push back wire lock (arrow).
Core (Flexible Shaft):
Pull shaft from adjusting device and pull core from the sheath (arrow).
Drive Motor:
7 To remove the motor loosen the 4 screws (arrow) of the mounting. Pull flexible shaft from adjusting device, disconnect electrical wire from 2- pole terminal block.
Note: Motor can now be removed with shafts.