Removal and Installation

REMOVAL AND INSTALLATION
- Raise hood to vertical position.
- Disconnect ground cable at battery.
- Drain coolant at engine and radiator.

Air Intake Boot:

- Take air scoop off the air filter and remove.
- Remove tensioning device for Poly V-belt.
- Remove power steering pump with lines connected and position to the side.
^ Tightening Torque: 25 Nm (18.5 ft lbs)
- Loosen bolt (29) for heating water return line.
- Remove heating water return line (25) from coolant pump and place to the side.
- Detach coolant hoses.
- Unplug ignition cable from bracket.





- Remove bolts (263, 264) at the crankcase.
^ Tightening Torque: 25 Nm (18.5 ft lbs)
- Remove coolant pump (265).
- Install in reverse order, paying attention to the installation notes.
- Check for leaks.

INSTALLATION NOTES:
- Replace coolant pump seal, pump body to engine block.
- The thermostat must be installed such that the ball valve is positioned at the highest point.
- Replace coolant thermostat O-ring.
- Replace seal of heating water return line.