91-841 Remove/Install Soft Top Control Module

91-841 Removing And Installing Soft Top Control Module







NOTE: It is necessary to disconnect the battery because the soft top control module is active for approx. 60 minutes after the ignition has been switched off.

Reinstall in opposite order.
Check function (91-830).







Testing as of 06/95
After installing the new control module test the system with the hand-held tester (HHT).
Connect the HHT to the 38-pin data link connector (X11/4) with a multiplexer.
Check roll-over bar for proper function; the rollover bar should actuate (91-830).