Rear Axle Switch/Sensor (For Roll Bar): Service and Repair

Removing and installing left and right rear axle switches up to 05/95





Removal

Roll-over bar
put up with convenience switch
Ignition
switch off
Negative pole on battery
disconnect and cover
Connector for rear axle switch on left (S3/2x) and right (S83/3x)
release by pressing (arrow)
Connectors
disconnect
Nuts (2)
loosen
Rear axle switches (S83/2,S83/3)
remove
Nuts (2)
retighten (4 + 0.5 Nm)

Installation


NOTE: The rear wheels must hang freely (rear axle suspension extended completely)


Rotating part (1) on both rear axle switches
turn to arrested position.
Nuts (2)
unscrew
Rear axle switches on left and right
position on bolts. Tighten nuts (2) hand-tight.
Rear axle switches
grip with hand on lever and position tip (3) against covering (4).
Nuts (2)
tighten (4 + 0.5 Nm).
Function of roll-over bar
check.
Roll-over bar should actuate. Testing and Inspection
Rotating part (1)
turn back to function position.