Remove/Install Rear Seat

Removal





1 Push detent at left and right to the rear and remove rear seat cushions.





2 Unscrew lower fastening screws outside and in center.

3 Swivel headrests in rear passenger compartment toward the rear.

4 Remove rear seat backrest in upward direction.

Installation





5 Engage rear seat backrest in upper holding links, paying attention to correct location of rear safety belts.





6 Screw on backrest below, paying attention to installation position of foam members in range of belt locks. Make sure that the foam members are not pinched-in behind seat backrest frame.

7 When installing rear seat, expose lap belt and engage rear seat at front in detent.

T-Sedan

Remove and install





1 Actuate handle on rear seat cushion and tilt rear seat cushion in upward direction.





2 Pull up locking lever on underside of seat cushion and remove seat cushion in upward direction out of bearing pin.





3 Expose belt locks at rear seat backrest, forcing off holder for this purpose and pulling elastic band out in downward direction.





4 Slide trim on backrest hinge in upward direction and remove.





5 Unscrew screws (3 each) on backrest hinge.





6 Pull lock from bearing bolt.

7 Pull rear seat backrest out of bearing and remove.