Model 124.034/036
Group: 82Number: 286
Date: November 1992
SUBJECT:
MODEL 124.034/036
CD CHANGER INSTALLATION
1. Remove hardware from shipping box and verify contents.
2. Remove shipping screws (2) from CD changer. Reposition screws in storage location (1). Cover screws holes with dust covers (Fig. 1).
3. Place template on main bracket. Position trunk bracket underneath and align fastening holes.
Note:
The M10x10 bolt is to be placed in the non-circled 400E/500E template location. Fasten three M4x6 belts into remaining locations.
Be sure to use template to select proper fastening holes.
4. Remove trunk floor mat and right wheel well liner.
5. Secure CD bracket to left rear threaded insert on trunk panel underneath hatshelf (as viewed from rear of car).
6. Punch locations for 3 holes with template in place. Remove bracket and drill 3 mm holes. Clean metal shavings. Apply zinc dust paint.
7. Secure bracket with M10x10 and three M5x15 bolts.
8. Remove end plate from CD changer unit.
9. Carefully remove the vertical mount springs and reinstall in horizontal position. Replace end plate. Repeat procedure on other side of CD changer unit.
10. Install side brackets on top of CD changer unit with the mounting holes of the brackets facing out (Fig. 3). Secure with two M4x6 bolts.
11. Attach interface box to rear of CD changer unit using three M2x5 bolts (Fig. 4).
12. Connect the black BUS cable from interface to CD changer (connector does not utilize retaining clips).Connect female 4-pole connector from interface to male 4-pole connector from CD changer unit.
13. Disconnect 4-pole female power supply connector from tuner/amplifier. Connect male 4-pole power connector from adapter harness to 4-pole female connector just removed from tuner/amplifier. Connect 4-pole female connector from adapter harness to tuner/amplifier.
14. Disconnect white BUS cable connector from tuner/amplifier and reconnect to female connector on adapter harness. Connect male connector on adapter harness to tuner/amplifier.
15. Route harness up to right hinge and next to bracket. Secure with cable ties.
16. Reinstall wheel well liner.
17. Connect grey BUS cable connector to grey dot and black BUS connector to remaining connection. Connect female connector from harness to male connector on CD changer interface.
18. Slide CD changer unit into bracket until the unit audibly clicks into position. Secure with two M5x10 bolts.
19. Install CD changer cover.
20. Reinstall trunk floor mat.
21. Install CD magazine in to CD changer unit.
22. Test function.
Parts Information
Recommended Labor Time