Model 124.066
Group: 82Number: 287
SUBJECT:
MODEL 124.066
CD CHANGER INSTALLATION
1. Remove hardware from shipping box and verify contents.
2. Remove shipping screws (2) from CD changer.
Reposition screws in storage location (1). Cover screws holes with dust covers (Fig. 1).
Be sure to use template to select proper fastening holes.
3. Install side brackets on top of CD changer unit with the mounting holes of the brackets facing out (Fig. 2). Secure with two M4x6 bolts.
4. Attach interface box to rear of CD changer unit using three M2x5 bolts (Fig. 3).
5. Remove trunk floor mat and left wheel well liner.
6. Attach CD bracket to J-bracket by aligning four pre-threaded inserts on J-bracket with holes on CD bracket (Fig. 4).
7. Install bracket assembly to left trunk floor. Position bracket mounting holes over three rearmost threaded inserts (Fig. 5).
8. Secure with three M6xlO bolts.
9. Connect the black BUS cable from interface to CD changer (connector does not utilize retaining clips).Connect female 4-pole connector from interface to male 4-pole connector from CD changer unit.
10. Disconnect 4-pole female power supply connector from tuner/amplifier. Connect male 4-pole power connector from adapter harness to 4-pole female connector just removed from tuner/amplifier. Connect 4-pole female connector from adapter harness to tuner/amplifier.
11. Disconnect white BUS cable connector from tuner/amplifier and reconnect to female connector on adapter harness. Connect male connector on adapter harness to tuner/amplifier.
12. Route harness and cables. Secure with cable ties.
13. Reinstall wheel well liner.
14. Trim trunk floor mat around footprint of CD changer bracket.
15. Reinstall trunk floor mat.
16. Connect grey BUS cable connector to grey dot and black BUS connector to remaining connection. Connect female connector from harness to male connector on CD changer interface.
17. Slide CD changer unit into bracket until the unit audibly clicks into position. Secure with two M5xlO and two M4x6 bolts (on front of J-bracket).
18. Install CD changer cover.
19. Install CD magazine in to CD changer unit.
20. Test function.
Parts Information
Recommended Labor Time