Model 140
Group: 82Number: 289
Date: November 1992
SUBJECT:
MODEL 140
CD CHANGER INSTALLATION
1. Remove hardware from shipping box and verify contents.
2. Remove shipping screws (2) from CO changer. Reposition screws in storage location (1). Cover screws holes with dust covers (Fig. 1).
3. Place template on main bracket. Position trunk bracket underneath and align fastening holes (use center and two w-C140 holes). Fasten with three M4x6 bolts.
Be sure to use template to select proper fastening holes.
4. Install side brackets on bottom of CD changer unit with the mounting holes of the brackets facing out (Fig. 2). Secure with two M4x6 bolts.
Figure 3:
5. Attach interface box to rear of CD changer unit using three M2x5 bolts (Fig. 3).
6. Remove trunk floor mat and left wheel well liner.
7. Connect the black BUS cable from interface to CD changer (connector does not utilize retaining clips).Connect female 4-pole connector from interface to male 4-pole connector from CD changer unit.
8. Disconnect 4-pole female power supply connector from tuner/amplifier. Connect male 4-pole power connector from adapter harness to 4-pole female connector just removed from tuner/amplifier. Connect 4-pole female connector from adapter harness to tuner/amplifier.
9. Disconnect white BUS cable connector from tuner/amplifier and reconnect to female connector on adapter harness. Connect male connector on adapter harness to tuner/amplifier.
10. Route harness along existing harness. Secure with cable ties.
Figure 4:
11. Measure back 13 cm from trunk sill panel to rear edge of CD changer bracket. Trace footprint of CD bracket onto trunk matting. Carefully cut matting along front and rear marks for bracket and fold matting inwards (Fig. 4).
12. Fasten bracket using three M5x15 sheet metal screws.
Note:
Press CD changer bracket flush against rib on trunk floor.
13. Trim underlying fibers away so that trunk matting covers mounting screws of CD changer bracket. Trim excess matting as necessary.
14. Reinstall wheel well liner.
15. Connect grey BUS cable connector to grey dot and black BUS connector to remaining connection. Connect female connector from harness to male connector on CD changer interface.
16. Slide CD changer unit into bracket until the unit audibly clicks into position. Secure with two M5xlO bolts.
17. Install CD changer cover.
18. Reinstall trunk floor mat.
19. Install CD magazine in to CD changer unit.
20. Test function.
Parts Information
Recommended Labor Time