Control Module Box, Remove/Install

1 Bracket
2 Bracket
3 Screws
4 Screws
5 Control module bracket
X11/4 Data link connector

1. Remove cover on right of engine compartment.
2. Remove module box control modules.
3. Detach brackets (1, 2).
4. Remove data link connector (X11/4).
5. Unscrew screws (3, 4).
6. Disconnect blower motor connector.
7. Take out control module bracket (5).

Installation Note: Check gasket for damage and correct seating and replace if necessary.

8. Pull wiring harnesses out of module box housing.
9. Remove module box housing.
10. Install in reverse order.

Special Tool: