Control Arm: Service and Repair

Remove/install Camber Strut

Shown On Model 210:

CAUTION: Installation: Replace self-locking nuts and bolts

DANGER:
- Risk of death. Death may result if vehicle slips or topples from the lifting platform.
- Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.

1c,1d Rear axle mount bolt, front and rear

NOTE:
- Only model 210 removal: If the direction of installation of the bolt (2a) is from the front, the front and rear rear axle mount bolt (1c, 1d) is not detached.
- Installation: recut thread on frame floor with tap.

2 Camber strut

CAUTION: The rear axle shaft must be horizontal when tightening the nuts.

2H Sleeve in wheel carrier to reduce diameter