Disconnection/Connection Notes For Electrical Connectors

Disconnection/Connection Notes For Electrical Connectors


Connectors of electronic accelerator pedal or Tempomat cruise control M16/1x1, M16/2x1, M16/3x1 at right front wheelhouse and M16/4x1 at left front wheelhouse.






Unplugging
1 Press back detent hook with screwdriver; when doing this, hold cover of connector tight and turn to the left.

NOTE: Turning the cover is assisted by the integral spring.

2 Take off connector.


Plugging together
1 Fit on connector and turn cover to the right against the spring force until the detent hook engages.


Engine separation point X26/2 at right front wheelhouse.






Unplugging
1 Turn over locking bar in direction of arrow as far as the stop.
2 Take off connector.

Plugging together
1 Fit on connector.
2 Turn over locking bar in direction of arrow as far as stop (b).


Connector, starter harness X27






Unplugging
1 Pull off rubber grommet (arrow) below the vehicle on the right of the firewall.
2 Unscrew union nut and unplug connector.






3 Unclip connector (arrow) in right front footwell.


Plugging together
1 Clip in connector (arrow) in right front footwell
2 Plug in connector on underside of vehicle and screw on union nut.
3 Fit on rubber grommet (arrow) below the vehicle on the right of the firewall.


Connector, emergency tensioning retractor/airbag X11/7, X11/13 in front right footwell






Unplugging
1 Push locking bar in direction of arrow as far as the stop (a).
2 Take off connector.

Plugging together
1 Fit on connector so that the markings A and B on the locking bar and on the connector housing are lined up.
2 Push locking bar in direction of arrow as far as the stop (b).


Connector, door separation point X35/1, X35/2 at A pillar






Unplugging
1 Use screwdriver to press out locking bar for the respective row of connectors or couplings approx. 5 mm in direction of arrow.
2 Pull out connector or connector.

Plugging together
1 Plug in coupling or connector.
2 Press in locking bar.


Connector, door separation point X35/3, X35/4 at B pillar






Unplugging
1 Take off cover.
2 Turn connector 180° to the left with special tool 140 589 00 09 00.
3 Take off connector.

Plugging together
1 Fit on connector and turn 180° to the right with special tool 140 589 00 09 00.






2 Fit on cover.






Special tool