C. Wiring Harness - Model 210

1. Run display unit (DU) cable (round 13-pin connector), Positive (red), Ignition (black), Speed Sensor (green), Ground (brown), and Speaker (yellow connector) forward, leaving Reverse (white) and 26 pin connector in trunk area.

2. Positive (KL 30) will connect to the fuse box under the rear seat, run other wires to the front via the right-hand harness channel, follow existing wiring harness and tie with loom ties.

3. Speed signal will connect at terminal in right front harness channel.





4. Run the DU cable, Speaker, and Ignition (KL 15) wires up right side near A pillar (Figure 2) and route across the under dash panel to the right side of the console.





5. Run display unit cable and Ignition wire through center console. Ignition will connect in back of radio and Display Unit cable will go up behind the A/C push button unit and up to the center vent. (Figure 3)





6. File approximately a 11 mm notch into the upper left corner of the air vent for the display unit cable to pass through (Figure 4).

7. Pull out enough Display Unit cable to reach the right side of the vent. Working front to back tuck wire in track.

Wire Color Label

Positive (KL3O) Red + term 30
Ground (KL31) Brown term 31
Ignition (KL15) Black Ignition
Reverse White reverse gear
Speed Sensor Green speed sensor
Speaker Yellow
Connector