H. Speaker - Model 210

1. Cut a 76 mm (3 in.) diameter hole into the carpet of right side of center console for the speaker. Distance from the center of the speaker to the side seam is approximately 550 mm (22 in.) and from the center of the speaker to the floor is approximately 145 mm (6 in.) (Figure 14). The inside diameter of the fastening plastic ring of the speaker can be used as a template.

Note:
Before making cut, verify that speaker has enough clearance behind the carpet to fit.

2. Route speaker cable along the Display Unit cable to the right side of the center console.

3. Insert speaker into cut hole and secure by screwing on the fastening ring on the back side.

4. Connect speaker wire and reinstall carpet, B pillar cover, door sill trims and rear seat.