Model 202
Group: 82Number: 343
Date: October 1995
SUBJECT:
MODEL 202 M.Y. 1996
INSTALLATION OF CD CHANGER
1. Remove hardware from shipping box and verify contents.
2. Remove shipping screws (2, Figure 1) from CD changer. Place shipping screws in ID card bag. Cover screws holes with dust covers.
2a. Set orientation adjustments on sides of CD changer to vertical (V). Secure with adhesive covers.
3. Remove trunk floor mat.
4. Locate factory bus cable in right wheel well.
5. Attach CD changer to CD mounting bracket using four screws.
6. Connect bus cable to CD changer.
7. Position CD changer unit into right wheel well so that the stud on the bottom of the mounting bracket fits into the pre-drilled mounting point located on side member behind battery (arrow, Figure 3).
8. Continue to position the CD changer unit so that the tabs on mounting bracket align over pre-drilled factory mounting locations.
9. Secure top mounts with screws. Secure bottom mount (stud) with 6 mm nut using a 1/4" drive.
10. Install CD changer cover.
11. Install CD magazine in to CD changer unit.
12. Reinstall trunk floor mat.
13. Test function.
Parts Information
Recommended Labor Time