A. Mobile
Model 1291. Remove carpeting from center console.
2. Cut and remove all styrofoam from underside of carpeting. Remove material from lip around the underside of carpeting so reinforcing plate can lie flat.
3. Place reinforcing plate on back of carpeting (Figure 4).
4. Locate, punch and drill four inner holes to 5 mm.
5. Insert four screws through reinforcing plate and carpeting. Mount cradle on carpeting and tighten screws.
6. Drill outer holes through carpeting to match the diameter of the mounting plate holes.
7. Remove two forward screws in center console compartment.
8. Place angular bracket in console with raised edge of bracket pointing towards the rear of the compartment (Figure 5). Secure bracket using the two removed screws.
9. Locate two harnesses at rear of compartment. A coaxial antenna connector is taped to a 12-pole data cable labeled PORTABLE PHONE. The other 12-pole data cable is not labeled.
10. Connect unlabeled harness to back of cradle. The other harness is not used.
11. Replace carpeting and cradle into center console compartment, routing the harness along the right side of the compartment. Secure carpeting with two screws to angle bracket in compartment.
12. Connect HS coil cord to cradle. Place handset in cradle.
Model 140
1. Remove three screws which secure cupholder to center armrest. Remove cupholder assembly. Carefully drill out four dimples on underside of cupholder assembly using 4.5 mm drill bit. Attach cradle to cupholder assembly using four screws.
2. Reinstall cupholder assembly by setting rear portion into position first. Secure assembly to armrest with three screws (note that the longer screw is used to secure the outer portion of the assembly, while the two shorter screws are for securing the bottoms of the cupholders wells).
3. Remove cover from fixed connector in back of armrest tray. Connect pigtail connector from cradle straight into fixed connector.
4. Install trim piece behind cradle by sliding front of trim piece under cradle. Make certain that the coil cord passes through notch on trim piece - do not pinch coil cord. Secure trim piece by pressing down gently (Figure 6).