Installing Transmitter/Receiver (1/97 Production)

1. Unpack contents of installation kit and compare to parts list at end of Work Instructions. Read through entire procedure to familiarize yourself with sequence of instructions and parts. Remove Operating Guide from kit and place in owner's literature pouch.

2. Disconnect and cover negative battery terminal.

3. Remove left rear wheel well liner.





4. Set transceiver bracket into place on wheel well (Figure 1). OBSERVE WIRE ROUTING SHOWN IN DIAGRAM. The two lower feet mount on 2 studs on wheel well. The upper stud mounts through a pre-punched hole in the hinge reinforcement forward of the antenna. Place two plastic nuts over studs. Secure upper mount with M5 nut. Tighten all 3 fasteners.





5. Mount four adhesive rubber strips to U-shaped transmitter/receiver bracket (Figure 2).

6. Connect 25-pole connector to transceiver. Secure with integral thumbscrews.

7. Position transmitter/receiver onto trunk bracket with connectors facing fender, and antenna connector facing rear of vehicle.

8. Connect transmitter/receiver bracket assembly to main bracket using T15 screws provided.

9. Locate integrated cellular antenna cable in left rear wheel well. Connect to transmitter/receiver and secure cable to other harnesses, using cable ties.

10. Reinstall wheel well liner.