Installing In-Dash Controller (IDC) (2/97 Production)

22. Remove radio.





23. Remove storage box by pushing down on tab (arrow, Figure 5) while sliding box out of console.

24. Remove liner from framed lid assembly. Pry up gently on the retaining tabs (8) located on the top and bottom of the frame. Slide the box out of the frame from the rear.

25. Slide the IDC into the frame from the rear against the left side of the frame. Slide the small storage box (from the CTEL kit) into the opening to the right of the IDC. The projection on the storage box slides into a channel in the frame.

26. Partially reinstall the frame, IDC and storage box into the console. The rib in the console slides into a channel on the frame. Connect the RJ-45 connector from IDC to the vehicle harness connector.





27. Push the IDC assembly into the console until it clicks into place (Figure 6).

28. Reinstall the radio (Figure 6).

29. Reconnect negative battery terminal.

30. Program telephone.





31. Test function.

Note:
To avoid disconnecting a call when replacing the handset in the cradle, in order to use the hands-free speaker, the "Hang-up Off" feature (as described in the Operation Guide) must be enabled.