Version Coding and Diagnostic Testing
H. Version Coding and Diagnostic Testing1. Connect StarDiagnosis (DAS) to the vehicle and perform the version coding outlined below:
^ Skip to step 3, if the telephone is NOT installed.
2. Using path: Control units/Information and communication/ICM/Standard version coding/Optional equipment, set CTEL to Exists
3. Using path: Control units/Information and communication/D2B/Control module adaptations/D2B Nominal configuration, set the D2B ring configuration per the following table:
4. Return to the D2B functions menu. Using path: Actual values/D2B Actual configuration, verify that the version coding input above (specified value) matches the actual configuration performed during installation (actual values). If a difference exists, the ring has been improperly configured and must be disassembled and properly reconfigured.
NOTICE! DO NOT alter the configuration in step H3 to match the vehicle configuration. Failure to have the configuration set as indicated in the table will result in erroneous system operation and/or intermittent functioning of some or all components.
5. Check the DTC memory of all installed components and the head unit. Any present DTC(s) should be investigated and the source identified. Once identified, the source of the DTC(s) should be corrected and the DTC memory cleared.
Note: Powering up the newly installed system prior to the above described version coding, will set D2B ring configuration errors. These errors may be ignored during the initial DTC check. If after clearing the DTC(s), they return in the next step, a configuration error is present and must be located and corrected.
6. Confirm that no new DTC(s) have been set in the D2B system group.