RAV - Recalling Actual Values with HHT

The following tests and activations are possible via the Hand-Held Tester.

Preparation for recalling actual values:

1. Connect the Hand-Held Tester (HHT) to X11/4, according to diagram.
2. Voltage supply to control modules and CAN data lines OK.
3. Battery voltage > 11 V.
4. Ignition: ON
5. All CAN data lines must be connected,
6. Fuses OK.

NOTE:
Actual values for the system being checked may be located in other control modules, therefore it is important to check the DTC memory on all control modules that are relevant to the system being checked.

When calling up actual values, all actual values will appear for that particular control module.

Erasing the Mirror, steering column adjustment, heated mirrors (MSC) DTC memory, will also erase the DTC memory for the Combination Control Module (N10-1) and Convenience Feature (CF).

Abbreviations:
ESV L Left seat adjustment
UBF Lower control field control module (N72)
TSG 1 Front driver-side door control module (N69/1)
TSG 2 Front passenger-side door control module (N69/2)

The above noted abbreviations are in the second column of the following actual values tables in bold type to advise of hints (regarding in which of the control modules the actual values or activations are stored).

Special Tools:

Test Steps

Test Steps 1 - 3:

Test Steps 4 - 6:

Test Steps 7 - 9:

Test Steps 10 - 11:

Test Steps 12 - 13: