Individual Flap Test
Air Conditioning (A/C)
Models 208 as of MY 1998
Individual Flap Test (via A/C Pushbutton Control Module [N22])
Notes:
1. The display window in the A/C pushbutton control module (N22) will show the test step. Pressing the various buttons will activate the individual vacuum actuators (refer to test table). The LED on the depressed button lights up.
2. The temperature control is maintained during the duration of the test
Preparations for Test
1. Engine : At idle
2. Press left and right AUTO buttons.
3. Set temperature selector to 72°F.
4. Manually open the side and middle air vents.
5. Press REST and Recirculated Air for more than 5 seconds.
6. The left display will show "0" and the right display will show "LO".
7. By pressing the left AUTO button, the next test step is displayed. To switch from "LO" to "HI" press AUTO on the right side (see table).
8. Press REST to end test program.
Note:
- Two stage vacuum actuators function at full stroke (100%) only, if the long stroke (80%) and the short stroke (20%) are pressed.
- Pressing the short stroke (20%) by itself does not change the flap position.
- The blower motor will be powered with 6V during the indvidual flap test.test.
