Radius Arm: Service and Repair

Remove/install Radius Rod

Model 210 Illustrated:

CAUTION: Installation: Replace self-locking nuts

DANGER:
- Risk of fatal accident from vehicle slipping or toppling off the lift platform
- Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.

3 Torque strut

NOTE: Models 129, 170, 202, 208, removal: Push wheel carrier forwards and release before pulling out hexagon bolt at rear axle carrier.


CAUTION: The rear axle shaft must be horizontal when tightening the nuts

3h Sleeve in wheel carrier to reduce diameter
- Install sleeve for tension arm in wheel carrier.
112c Brake caliper dust shield without dent
- Only model 202.018/020/022/023/121: To removing bolt of tension arms from wheel carrier brake caliper, push dust shield approx. 3 mm towards brake disk.