AR40.20-P-0332I Check and Adjust Rear Wheel Toe

Check and Adjust Toe On Rear Axle
- except CODE (979) Special protection version
- except CODE (Z07) Top protection

Shown On Model 220 With Airmatic:

Eccentric Rubber Mount:

1 Check vehicle level at front and rear axle with electronic inclination meter and adjust, if necessary
2 Adjust toe-in with cam bolt (60a) at the mount of the left and right tie rod (60) at the rear axle carrier

NOTE:
- If the test values are not achieved, the rubber mount installed as standard (60b) can be replaced by an eccentric rubber mount (60c).
- The offset of 1.5 mm makes it possible to decrease the toe-in by 15 inch (Fig. A) or to increase the toe-in by 15 inch (Fig. B).