AR46.40-P-0201I Remove/Install Inner Tie Rod With Axial Joint

Remove/install Inner Tie Rod With Axial Joint

Shown On Model 220:

DANGER:
- Risk of death. Death may result if vehicle slips or topples from the lifting platform
- Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer

1 Remove front wheels
2 Remove track rod
3 Remove bellows
4 Counter gear rack (arrow)

NOTE: Using open-end wrench 27 mm

5 Remove track rod with ball pint (12)

CAUTION: Do not use force (hammer blows, excessive leverage)

6 Install in the reverse order